∷ Product Introduction ∷ 

 The dynamic torque sensor in the LT-D3 LT series (the specific size of telephone consultation) the smaller size of a. LT-D3 torque sensor to be improvements made by foreign products. Product look more compact and more reasonable line processing, able to output standard analog signal to be more applicable to the needs of domestic customers, while taking into account the excellent quality of foreign products, a good foreign alternatives. This series torque sensors have the following: 1. Torque measurement capabilities; energy and signal non-contact transmission; output signal digitized feature. Can pass the static torque signal, the rotation torque signal, the dynamic torque signal, the static torque signal. Signal transmission and whether the rotation speed and the steering has nothing to do. Can be adapted to long, high-speed operation. High accuracy, good stability; 5 small size, light weight, easy to install; without repetition zero can be continuously passed reversing the torque signal; 7. Slip ring wear can be high speed a long-running; 8 Immunity strong; can be anywhere, in any direction to install; technical indicators. range: 10,50,100,200,500, 1000N · m 2. accuracy: 0.5 % F · S 3. applicable speed 20,000 rev / min or less. ambient temperature: 0 ℃ -50 ℃. Frequency response: 100 μs. weight = 0.8Kg--2 Kg. output signal: 0-12v square wave frequency load current <10mA; zero torque: 10 KHZ; positive full scale: 15 KHZ; reverse full scale: 5 KHZ. 8. signal socket: (1) 0V. (2) +15 V. (3) - 15V (4) (speed signal). (5) The torque signal. This series torque sensor transformer sensing power supply, long-term, widely used in motors, generators, gear reducer, the diesel engine's torque monitoring. If you need to measure the speed, as long as the shell of this series torque sensor installed on a dedicated speed sensor, tachometer wheel can be measured at every turn 6 - 60 square wave speed signal. (1) using two sets of coupling the sensor with a torque sensor installed between the power source and load. (2) It is recommended to use the flexible elastic or universal joint couplings, in order to ensure concentricity ∠ 0.1mm power and load equipment must be fixed and reliable to avoid vibration. 4 the base of the base and equipment of the torque sensor as much as possible the use of flexible fixed (swing), to avoid the moment. Signal processing using the LT-Series torque analyzer directly displays the torque value; Directly to the torque-frequency signals sent to a computer or PLD processing; Converted to 4-20m A or 1-5V analog signal, use: 1. Wiring must be correct; 2. ± 15V range: shall not be less than ± 14.5V shall not exceed ± 15.5V; signal line output may not, the power short-circuit, the output current is not greater than 10mA; 4. Shielded cable The shield must be connected with the public side of ± 15V power supply (power ground). Use If in doubt please contact the company, within the warranty period shall not disassemble.